What a start to 2026! Aurora Power Consulting are pleased to announce that we are now part of the Morson Praxis group. This exciting development extends Morson and Aurora’s capability and service offering, whilst maintaining

As a power systems analysis consultant we regularly get asked to carry out arc flash studies. We are always happy to do them, as it is a useful exercise in most cases. However, what we

Introduction Limiting the use of the DNO / DSO network during congested hours is a well established process as part of Active Network Management (ANM). This allows loads and generators to connect to networks faster

The IEC 60909 standard is well established, and used across most of industry to calculate the maximum fault currents that can occur on a system. The primary use of the standard is to select switchgear

Introduction When we carry out an earthing study for a site, one of the key questions we try and answer quickly are ‘Is the site a Hot Zone?’ and ‘Is the site a high EPR

Introduction In earthing studies, one of the most important steps to undertake is to calculated the fault current actually injected into the ground grid vs fault current that will return via metallic paths such as

Introduction Measuring soil resistivity by direct electrical measurement is fundamental to designing a safe and cost-effective earthing system. It is the foundation on which good design is built on. If the soil resistivity input data

A few weeks ago now, our MD (Steve Sommerville) gave a short presentation in Distributed Energy Resource (DER) Forum in relation to energisation of transformers on large generation sites with multiple transformers. The current P28

An interesting article below from the BBC discussing the ongoing issue with constraints, and the overlap to zonal pricing. It is a hot debate, with a certain amount of heat on both sides, and as